Overkill Ikea Lack brace by AquaHaven

AquaHaven

Hobby & DIY>Other Hobby & DIY

Print Profile(2)

All

X1 Carbon

P1S

P1P

X1E

0.28mm layer, 2 walls, 10% Gyroid infill

1.5 h

1 plate

4.6(5)

0.2mm layer, 3 walls, 10% infill

8.8 h

2 plates

Open in Bambu Studio

Boost

100

119

Released

Description

From my overkill series, some stabilising braces for your Ikea Lack table.

They reduce wobbling, thus reducing vibrations and making your print quality better, and your printer quieter.

As with all my overkill designs, this is thick, stable and durable. It follows a “no support” ideology, so it prints with no supports and the best is to print this laying flat. Print 4 pieces. Can be printed with any material and any infill.

It fits any Lack table.

It includes to 2, 3mm holes so use any screw bigger than that and it will self tap. Holes are recessed to hide the screw head.

Comment & Rating (5)

@fisk1234ost

Boosted

Print Profile

0.28mm layer, 2 walls, 10% Gyroid infill

will add another star when I get them installed

@adamgda

Print Profile

0.28mm layer, 2 walls, 10% Gyroid infill

@flynn

Print Profile

0.28mm layer, 2 walls, 10% Gyroid infill

fantastic thanks

@CeeToo

Print Profile

0.28mm layer, 2 walls, 10% Gyroid infill

In general very good table support, printed 8 times for each corner to reduce wobbling. Only upgrade I would do is to have more wholes prepared for the screws not only for the outer area but also the inner one.