P-51 Mustang From WWII!

All information can be found here: (Parts, details, etc.) Free Plans 3-D Printed P51D RC Airplane!!! (youtube.com)

Link for Cura Profile: https://www.dropbox.com/scl/fi/r5n8h21xh9chg2lkvq9n5/profile-for-mdot.curaprofile?rlkey=jj8u7m408t6ga6fpui96m39ya&st=rbuph7n3&dl=0

https://www.youtube.com/watch?v=sm94YOQ8hvg . As seen in the photo, I was able to print almost all the pieces at once on my Ender 3 V3 SE! G-code for ender 3 are attached! I do recommend using G-code, but if you are not, side walls 0.8 for more strength, 0.6 for better performance, 10% lightning infill. I have printed 3 models so far and I think either thickness is ok. Helpful photo:

Interesting finding, will research this more:

Remix info: Everyone in the comments on this plane said it didn't fly, so I wanted to figure out why, if you print the g-codes which are 0% infill and 0.6 walls, it should turn out, the one thing I did alter was the spinner base, it does not fit so I modified it to. I also made landing gear and pins to connect the parts!