Search models, users, collections, and posts
Keyblade updated
Remixed by
IP Report
Print Profile(2)
0.2mm layer, 3 walls, 15% infill
Designer
28.1 h
7 plates
0.2mm layer, 3 walls, 15% infill
Designer
19.3 h
7 plates
Open in Bambu Studio
Boost
606
1516
88
88
1.4 k
745
Released
Description
I have updated the following:
- hand grip changed from smooth to woven grip.
- base of handle updated to allow for easier attachment of keychain.
- updated supports to address issues with printing original model.
- updated core of model to allow you to place a wooden dowel down entire model and stabilize. The dowel size I used is ¼ inch wide and 4 feet long. I had to trim off about 10 inches from the dowel, so you could probably just use a 3 foot dowel. Dowel not required, but I do think it is helpful.
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (88)