Mechanical Iris

Copyright Claim

Mechanical Iris

Boost
67
132
11

Print Profile(1)

All
P1P
P1S
X1
X1 Carbon
X1E
A1

0.2mm layer, 2 walls, 15% infill
0.2mm layer, 2 walls, 15% infill
5 h
6 plates
3.0(2)

Boost
67
132
11
0
237
89
Released

Description

print 16 blades and print them at 0.15mm layer height as they are 0.3mm thick

Comment & Rating (11)

Please fill in your opinion
(0/5000)

A1mini可以这样摆放,一盘打印8个只需四次而非五次
0
Reply
套料大师b( ̄▽ ̄)d
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Just didn’t work out for me. The threads were all off
0
Reply
Print Profile
0.1mm layer, 2 walls, 15% infill
no instructions on how to put together. after FINALLY figuring it out it was so frustrating to assemble properly I threw it out.
2
Reply
thats a shame. sorry i didnt write out an explanation. the steps to assemble are all in the pictures in order.
0
Reply
I was really excited about this but i ended up throwing them away. the threading is impossible to do. They have 3 point references and at the size, it's just not possible. Also first attempt to print directly through bambu handy was a total failure since there was no support. My consecutive attempts at finer profiles without support came out well - but i just couldn't thread the outer rings together. Currently reprinting at 50% scale to see if that will work but i'm doubtful. oh well. thanks for the upload anyway
1
Reply
Threw mine out too. This wasn't designed to be assembled easily that's for sure. The outer ring broke while trying to thread together as well.
The designer has replied
0
Reply
you must have been doing something very wrong to break it. or your print quality is whack. mine seems pretty sturdy.
0
Reply
I am new to 3D printing so I'm sorry if this is a simple mistake on my end. For the blades I set the X1C to 0.16mm profile and then manually changed layer height and first layer both to 0.15mm but when previewing the slicer output it still seems to be only one layer? I also watched the print and can confirm that the blades are one layer thick, but measure 0.25mm with calipers.
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
The print profile is no longer public
0
Reply
No more