Search models, users, collections, and posts
Splatoon Squid
IP Report
Print Profile(3)
0.2mm layer, 3 walls, 12% infill
Designer
1.4 h
1 plate
0.2mm layer, 3 walls, 12% infill
Designer
6.7 h
1 plate
![4 Color and Support for PLA [AMS]](https://makerworld.bblmw.com/makerworld/model/USff5628df058837/530033793/instance/2025-12-21_908c9f38a86d68.jpg?x-oss-process=image%2Fresize%2Cw_100%2Fformat%2Cwebp)
4 Color and Support for PLA [AMS]
11.6 h
1 plate
Open in Bambu Studio
Boost
302
603
35
3
515
161
Released
Description
Easy to print squid from Splatoon with manual support, seams and color. Single color and multicolor profiles are available. Multicolor profile uses a lot of waste and takes a bit of time. To minimize wobble and ensure the highest quality print, I’ve slowed down the print speeds considerably. However, I haven’t experienced any wobble issues at faster speeds; I'm just being overly cautious for better photos. During the initial overhangs, I also printed at 50% speed, which may be excessive.
If you are having issues, try at 50% speed. This was printed on a P1S.
Don't print on A1 or A1 mini
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (35)