Perler Bead Tweezers
Copyright Claim
Perler Bead Tweezers
Boost
18
42
20
Print Profile(2)
0.2mm layer, 3 walls, 30% infill
23 min
1 plate
0.2mm layer, 3 walls, 30% infill build plate only supports
26 min
1 plate
Open in Bambu Studio
Boost
18
42
20
0
136
141
Released
Description
Today, I was putting together Perler Fuse Beads with my cousins when we ran into a dilemma: There was only one pair of included tweezers. I happened to have my computer open, so I hopped onto Solidworks and threw together this .stl so I could print another pair. Hope you enjoy!
Comment & Rating (20)
All
Print Profile
0.2mm layer, 3 walls, 30% infill
Nice
1
Reply
Print Profile
0.2mm layer, 3 walls, 30% infill
it put supports between one of the guides between the guides inside of the tweezers so might I recommend supports on build plate only and hope for the best when it comes to bridging the new piece of the guide?
0
Reply
Print Profile
0.2mm layer, 3 walls, 30% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 30% infill
Helped a lot with picking up fallen over beads or placing them in hard to reach corners!
0
Reply
Print Profile
0.2mm layer, 3 walls, 30% infill build plate only supports
printed great
0
Reply
Print Profile
0.2mm layer, 3 walls, 30% infill
didn’t work for me but still, very good design
0
Reply
Print Profile
0.2mm layer, 3 walls, 30% infill build plate only supports
Worked awesome. Made this for a friend with a Chameleon
0
Reply
Print Profile
0.2mm layer, 3 walls, 30% infill
Support is dificult to remove. use the model that says support on bed only
(Edited)0
Reply
sucks ahh
0
Reply
Print Profile
0.2mm layer, 3 walls, 30% infill build plate only supports
Did break, however good design. I probably used the wrong filament. Good work!
0
Reply
License
This user content is licensed under a
Creative Commons Attribution
© 2024 MakerWorld