check the file this was remixed from here: https://makerworld.com/models/63745
you would use the slicer (Bambu Studio). not too difficult once you figure it out.
amazing quality I have experienced with this profile, I have printed many of these now for friends and family, I have attached some photos printed on the P1S these were all printed in Bambu labs filaments, the green is Bambu basic green and the white is Bambu matte ivory white, great addition with the area to hang them will look great on the trees 👍 only thing with this profile is the noses on the snowmen seem to be a little weaker than the original without the hole but not a big deal.
System doesn’t allow 5 stars rating unless print is terminated fully. I purposefully stopped the print before the last few layers in order to avoid the pinetree pointy upward-projecting branch ends and snowman’s prickly nose. Otherwise great design! Thanks Habitaritus for sharing it.