I needed to reorient the wing portion and add supports to get them to print well. Could not get them to print in the vertical orientation in this print profile. Otherwise these are great / hillarious!

good print.

bambu basic red pla printed 2 copies at the one time would say this is the way to do it to give sufficient adhesion with the brim, bambu handy app places them quite close which worked well, even at this one of the fins came loose on the last layer so top layer wasn't great on one but I hadn't washed the plate between prints so could have been my fault also, overall nice looking print, a groove for locating the glueing aswell could have been handy, would have rated higher but print down as a failure cause of an ams pull back fault so capped at 3 stars

Just for Crog Tunning but its funny. Print Profil work

really fragile

nice design bro ^^

not very good quality, the spoiler part jiggles a lot while printing

supports needed but not acticated

doesn't fit on every crock

funny