Search models, users, collections, and posts
The Button
IP Report
Print Profile(2)
0.24mm layer, 3 walls, 18% infill
Designer
44 min
1 plate
A1 mini 0.24mm layer, 3 walls, 18% infill
46 min
1 plate
Open in Bambu Studio
Boost
76
153
38
0
346
266
Released
Description
The Button is the main part of my series I will build on.
Housing and the spring inside is print-in-place. The cap will be pressfitt.
Extensions will be released based on the housing and will replace the cap.
You can already see a release mechanism in the spring wich allows me to add even more add-ons.
Once the print is finished, you just need to press the button hard once and it will release itself from the bottom.
Now you can press the button over and over again.
If you have any ideas on what I could built on top of the housing just tell me in the comments (need some feedback)! :-)
Happy printing!
You can check my other fidget switch here:
https://makerworld.com/de/models/62914#profileId-65584
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (38)