Fox Portrait

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 200x200mm in size. You can change X and Y but Z must remain the same.
You may print at higher layer heights below the Min Depth of 0.48mm
Actual Depth is 2.3mm

Filaments Used:
PLA BambuLab Basic Black Transmission Distance: 0.3
PLA BambuLab Basic Brown Transmission Distance: 2
PLA BambuLab Basic Jade White Transmission Distance: 5
PLA BambuLab Basic Orange Transmission Distance: 5
This print uses 4 unique filaments. Substitute as needed.

Swap Instructions:
Start with Black
At layer #6 (0.56mm) swap to Brown
At layer #8 (0.72mm) swap to Jade White
At layer #16 (1.36mm) swap to Brown
At layer #19 (1.6mm) swap to Orange
At layer #23 (1.92mm) swap to Jade White for the rest.