Print Profile(2)
Description
There are two print profiles:
- White Eyes
- Black Eyes
Both profiles are scaled to be approximately 4.5 inches tall. If you choose to scale, make sure to use uniform scaling, and individually scale both the feet and the ghost separately. The feet need to be minus one whatever you scale the ghost to. For example, if the ghost is 100% then the feet need to be 99%, if the ghost is 50% then the feet need to be 49%.
The feet fit tightly into the holes on the bottom of the ghost, so glue is not needed. When you line up the feet wiggle it a little until it lines up with the small notch properly and inserts in. Be GENTLE when inserting the feet and only press in enough until it locks in. If you go into hulk mode you'll snap the leg.
Tree support is needed since the beak and ghost are one piece. Snap the support off by grabbing it at the bottom of the ghost while pressing a little on the beak as it breaks away.
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (17)