Frame stand both wood texture and plain
Frame stand both wood texture and plain
Boost
18
33
6
Print Profile(4)
1 & 2 pcs no brim (use gluestick)
Designer
11.7 h
3 plates
no brim 1 wood & 1 plain (use gluestick)
Designer
8 h
2 plates
with brim 1 wood & 1 plain
Designer
8.1 h
2 plates
1 & 2 pcs with brim
Designer
11.9 h
3 plates
Boost
18
33
6
1
50
42
Released
Description
Use my print profile for best results, I cannot guarantee print profiles by others.
Here is a simple stand you can show off your 3D prints or picture frames, signs and HueForge prints. Simple to print and works with A1-mini and larger Bambu printers. STL files as well.
The regular version prints in just under 3 hours and the wooden texture prints in just over 5 hours. The wooden looks great printed in matte filament. No supports, printed in PLA. If you have problems sticking to the bed, then use the one with the brim, but I typically print these without brim.
Comment & Rating (6)
All
Print Profile
no brim 1 wood & 1 plain (use gluestick)
Very nice stand for larger prints!
0
Reply
Print Profile
no brim 1 wood & 1 plain (use gluestick)
Bed Adhesion Issue:I wasn’t able to get adhesion on my x1. I had dried the filament (and tried two different filaments), and the plate was cleaned and had nano on it.
The designer has replied
0
Reply
and that's why I've created two versions one with brim and one without brim. You chose the one without brim. try the one with brim. for what it's worth, I'm getting these to print reliably on a textured PEI plate that has just been cleaned and nano applied.
0
Reply
Print Profile
with brim 1 wood & 1 plain
0
Reply
Boosted
Print Profile
1 & 2 pcs no brim (use gluestick)
0
Reply
Print Profile
1 & 2 pcs no brim (use gluestick)
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld