Small spool spacer
Remixed by
Copyright Claim
Small spool spacer
Remixed by
Boost
18
39
22
Print Profile(2)
0.2mm layer, 2 walls, 15% infill
Designer
30 min
1 plate
0.2mm layer, 2 walls, 100% infill
56 min
1 plate
Boost
18
39
22
1
132
141
Released
Description
my small spools were too narrow for this adapter so I made a spacer
Comment & Rating (22)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
It didn't sit flush inside my particular spool as I was too lazy to measure, however after centering it and tightening the spool around it, it did the job!
The designer has replied
1
Reply
Thats a good-looking spool holder
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Bambu PETG Basic. Didn't calibrate anything. Printed fine.
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
printed great. came in handy for some cardboard spools I had as samples
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
perfect for my spools .Thank you
(Edited)
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
The spacers worked well for my smaller spools that were to thin. I would like if the spacers were a bit thinner but still work great.
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
exactly what I needed for a smaller spool!
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
great print file and that fit snug in my inland spools.
1
Reply
Print Profile
0.2mm layer, 2 walls, 100% infill
printed without any problems. thanks for sharing.
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
simple and fixed the issues with the original spool holder not griping small spools. printed 2 (one for each side) can now use all small spools
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Fit perfectly for Eryone 250g cardboard spools (4x250g tri-extrusion silk pack).
1
Reply
© 2024 MakerWorld