Simple Caliper / Pliers Holder for IKEA Skadis / Uppspel pegboard
Copyright Claim
Simple Caliper / Pliers Holder for IKEA Skadis / Uppspel pegboard
Boost
3
16
4
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
15 min
1 plate
Open in Bambu Studio
Boost
3
16
4
0
42
27
Released
Description
V2 model improved stability
internal size 19mm x 10mm
check out my other Ikea skadis models!
Comment & Rating (4)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
If you have enough room you can use it but for mit it uses too much space from the top and the bottom
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Simple but effective. I printed in PETG, but the fit was too tight for my skadis pegboard so I needed to trim of a bit plastic from the sides. Maybe scaling down a little might help.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
© 2024 MakerWorld