Print Profile(2)
Standard Profile PLA
Designer
27 min
1 plate
Standard Profile PLA CF
Designer
26 min
1 plate
Open in Bambu Studio
Boost
25
53
29
7
174
194
Released
Description
Simple ID-Card / Key-Card holder.
Fits standard 86x54mm key cards.
must be printed with supports (enable supports on print plate only)
Comment & Rating (29)
All
Print Profile
Standard Profile PLA
I need a card holder because hole in my card was broken. Card in this holder fits ok. It's tight and secure.
1
Reply
Boosted
Print Profile
Standard Profile PLA
The designer has replied
0
Reply
Thx 👍
0
Reply
Print Profile
Standard Profile PLA
(Edited)
1
Reply
Boosted
Print Profile
Standard Profile PLA
One of the best prints, the supports will release very well and it turned out so good!
The designer has replied
1
Reply
Thx 👍
0
Reply
Boosted
Print Profile
Standard Profile PLA
I recently printed a simple ID-Card / Key-Card holder designed to accommodate standard 86x54mm key cards. The holder required supports on the print plate, but the overall process was straightforward and the design proved to be very efficient. I had no complaints about the quality or the functionality of the print. In fact, I was so satisfied with the result that I ended up printing several more for my coworkers. Overall, this is a well-designed product that delivers good results.
(Edited)The designer has replied
1
Reply
Thx 👍
0
Reply
Print Profile
Standard Profile PLA
top
1
Reply
Print Profile
Standard Profile PLA
Relly good model with great adhesion
0
Reply
Boosted
Print Profile
Standard Profile PLA
The designer has replied
0
Reply
Thx 👍
0
Reply
Boosted
I use it everyday
0
Reply
Print Profile
Standard Profile PLA
printed perfectly, but too much supportd
0
Reply
Print Profile
Standard Profile PLA
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld