Christmas ball tree hanger #1
Boost
22
40
11
GIF
Print Profile(1)
0.2mm layer, 3 walls, 15% infill
Designer
1.6 h
1 plate
Boost
22
40
11
0
60
25
Released
Description
Designed for hanging in a tree. No supports are needed
Comment & Rating (11)
All
Nice model. Printed with tree support. Copper PLA
(Edited)
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
Failed
The designer has replied
0
Reply
What happend?
0
Reply
Replying to @Mr.Jay
At the top, the individual arms no longer fit together and were displaced. It seemed to me as if the sprouts' own weight caused this.
0
Reply
Was kicked off the plate halfway during the print :( Trying again.
The designer has replied
0
Reply
Make sure you clean the plate before print and do a bed level for print. I printed mine with the textured PEi plate from Bambu and it printed fine
(Edited)0
Reply
Replying to @Mr.Jay
Trying this again later this week.
0
Reply
Mine came out just ok. the top 75% was not great on my X1C. Might try again and slow it down about halfway through. I didn't use the textured PEi plate though as mentioned in the other comment. Just the cool plate my X1C came with. Cool design!
1
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
(Edited)
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivativesRelated Models
© 2024 MakerWorld