Pin Magnet Adapter
Copyright Claim
Pin Magnet Adapter
Boost
27
42
3
Print Profile(1)
0.2mm layer, 3 walls, 15% infill
Designer
13 min
1 plate
Open in Bambu Studio
Boost
27
42
3
1
20
5
Released
Description
Disney sells a lot of fun and nice looking pins, unfortunately not so many magnets....
But no worries you can make magnet adapters for your pins, and stick them to the fridge just as well!
Can most likely be used for non Disney pins as well, it's a nice press fit, so not a permanent modification you your expensive pins!
The Uploaded model fits three 8x1mm magnets, and has a center hole to push through your pin.
I'ts 10mm high, so it should fit most diameters of pins as well.
Comment & Rating (3)
All
should I scale this up to fit Disney pins? the hole is too tight to fit my pins and I don’t have a drill bit small enough to enlarge the hole.
The designer has replied
0
Reply
Hey, it probably has to do with your nozzle/pressure advance.
For me this fit Disney pins as-is. But I guess some are a bit larger or print a bit smaller.
You don't need to scale it completely, you can just add some hole compensation In the slicer.
https://wiki.bambulab.com/en/software/bambu-studio/xy-hole-contour-compensation
1
Reply
ok. maybe some of the bigger pins are thicker. I’ll fiddle with it and see. thank you.
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld