Santa Round Lantern by lindnjoe

lindnjoe

Household>Decor

Print Profile(1)

All

P1P

P1S

X1 Carbon

X1E

0.2mm layer, 2 walls, 15% infill

Designer

2.6 h

4 plates

4.8(43)

Open in Bambu Studio

Boost

165

281

553

1.1 k

Released

Description

Warning!! This takes patience to put together.

Santa Round Christmas Lantern with 3 thin layers that fit into a base. The layers have tabs on the bottom that fit into the slits on the base. The front layer with Santa is printed in two parts, you will need to put those two layers together to make one.

The layers are printed very thin at 0.2mm. Be careful when taking them off the heat bed. Slide the tabs on the end into the slits on the opposite end.

You can size up or down. For best results size up.

3 Layers to print and 1 base.

A tea light will sit in the middle.

You need patience when putting this together.

Comment & Rating (55)

@Duke_Silver

Print Profile

0.2mm layer, 2 walls, 15% infill

alright so as you can see it's a very nice piece, and kudos on the work. But as is mentioned in the writeup, it's super frustrating to put to put together. what I didn't realize is that you have to take it apart and put it together EVERYTIME YOU TURN OFF/ON TEA LIGHT! So I recommend you don't print this one. This needs to be remixed where the tabs pull through and can be attached.

The designer has replied

@lindnjoe

I just put a dab of glue in the slots before assembly. I then let it dry and it has stayed together fine.

@Jarrod

Fun print that was pretty quick from start to finish. Nice job to the designer!

The designer has replied

@lindnjoe

Glad you liked it!

@nickuspga

Print Profile

0.2mm layer, 2 walls, 15% infill

A little patients and a little glue and this went together wonderfully. Looks great at night with a simple led tea light.

The designer has replied

@lindnjoe

Looks great!

@user_561210569

Boosted

Print Profile

0.2mm layer, 2 walls, 15% infill

Translucent filament didn't work, but plain white looks great. It's fragile, but fast to print and easy to put together with a little care. Color changing light pucks with a remote from Amazon work perfectly with these! Great design, I'll be printing these to give out as gifts.

@itmotec

Print Profile

0.2mm layer, 2 walls, 15% infill

its ok, a little fiddling to build it and i had to glue it down, but it looks nice

@Mr.Hines

Print Profile

0.2mm layer, 2 walls, 15% infill

Easy print, looks good. Glad it’s made with very little filament, especially since I had to printed first plate twice — I pulled it off the Textured PEI plate too quickly, and it torn right down the middle. Lesson learned, so the remaining parts came out great.

(Edited)