Search models, users, collections, and posts
Pumpkin benchy accessory
Remixed by
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
25 min
1 plate
Open in Bambu Studio
Boost
56
97
7
2
44
36
Released
Description
For commercial licenses please visit my Patreon
🎃🎃🎃🎃🎃🎃🎃🎃🎃🎃🎃🎃🎃🎃🎃🎃🎃🎃🎃🎃🎃🎃🎃🎃🎃🎃🎃🎃🎃🎃🎃🎃🎃🎃🎃🎃🎃🎃🎃🎃🎃🎃
A 16mm pumpkin accessory to decorate your benchy for Halloween.
This remix has added a hole on the bottom that allows you to seat the pumpkin over the benchy chimney stack.
Note: It uses a negative part which doesn't show in the 3D preview above, but will slice and print correctly.
🎃🎃🎃🎃🎃🎃🎃🎃🎃🎃🎃🎃🎃🎃🎃🎃🎃🎃🎃🎃🎃🎃🎃🎃🎃🎃🎃🎃🎃🎃🎃🎃🎃🎃🎃🎃🎃🎃🎃🎃🎃🎃
🎃 Check out my other Halloween themed prints! 🎃
For commercial licenses please visit my Patreon
This remix is based on
This source model was used for remixing/sharing before its license was restricted.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (7)