Malkus Scanning / Painting Turntable
Copyright Claim
Malkus Scanning / Painting Turntable
Boost
7
10
3
Print Profile(2)
PLA version for scannining, 0.2mm layer, 2 walls, 15% infill. Not for heat curing after spraypaint!
Designer
2.5 h
2 plates
0.2mm layer, 2 walls, 15% infill
Designer
3.2 h
2 plates
Open in Bambu Studio
Boost
7
10
3
0
24
28
Released
Description
This is a turntable designed to reduce air traps to get better coverage when spraying.
It requiers a standard 608ZZ bearing to be fitted (8x22x7mm). Push the baring on to the small staft.
Push the top spider part inte the base with the bearing. If fit of the bearing is loose, ad a drop of superglue in the cut out section to lock the bearing in place.
Comment & Rating (3)
All
Print Profile
PLA version for scannining, 0.2mm layer, 2 walls, 15% infill. Not for heat curing after spraypaint!
worked as intended. I’ve been using this to paint all of my models
0
Reply
Print Profile
PLA version for scannining, 0.2mm layer, 2 walls, 15% infill. Not for heat curing after spraypaint!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivatives
© 2024 MakerWorld