Flush Cutter Grips
Copyright Claim
Flush Cutter Grips
Boost
7
8
7
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
1.2 h
1 plate
Open in Bambu Studio
Boost
7
8
7
1
18
11
Released
Description
Replacement grips for flush cutters. Mine seem to wear thru and the metal part sticks out.
It finally bother me enough to make this.
If you print the model file attached with a smooth outside then it should fit ok. The attached print profile has 'XY Hole Compensation' set to 0.15mm, because the fuzzy skin texture cannot be applied to the outside wall only so it make the inside fuzzy as well and needs the holes to be adjusted a bit bigger.
TPU only.
Comment & Rating (7)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
printed without issues from TPU
0
Reply
Boosted
Print Profile
0.2mm layer, 2 walls, 15% infill
cool
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
prints really well. slow but good and flawless profile. thanks alot for the design. save me money to buy a new cutter. haha. yeah mine broke off both side.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
probobably a good profile, didn’t realize it needed a felixblr filament
The designer has replied
0
Reply
:) it does say TPU only
(Edited)1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
printed great
0
Reply
absolutely perfect fit! good job on the design. I had the same problem as you and needed a solution. thankyou!
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
![Quick & Easy Flushing Volume Scale [0-400]](https://makerworld.bblmw.com/makerworld/model/US69921b9521a4b0/design/2024-06-24_890908823b7c6.jpg?x-oss-process=image/resize,w_400/format,webp)
© 2024 MakerWorld