D12 Kitcard 18mm V1

Greetings fellow adventurers,

Whether you need an emergency d12 or a quick little extra to put in a celebratory card for a fellow DnD’er, the “D12 kitcard” has you covered.

This d12 measures approximately 18.4mm face to face and features a layout of which the opposite sides sum to 13.

Given its reduced size, it matches the other smaller kitcard dice (D4-D6--D8-D10) a lot better than my previous larger D12 kitcards.
The print profiles with frame have also been optimized to provide a clean and easy break between the pieces and the frame. Due to this it is recommended to let the buildplate cool off before removing the prints.

Assembly Instructions (no glue required):

The joints of the pieces feature a slight dovetail design and require a bit of pressure to push into place. Once assembled it is not recommended to disassemble again.

1. Carefully remove each piece from the frame.

2. Gently bend the long face-pieces into shape.

3. Slide the 4-face of the die into the grooves of 3 & 8-face of the die.

4. Then go around connecting the other faces of the top and bottom part.

5. Place the 12-face on the top, aligned with the 9-face as shown below.

6. Place the 1-face on the bottom, aligned with the 4-face as shown below.

And there you have your new D12!

Options:

Following the recent update to makerworld guidelines there are just two print profiles with the following options:

• duo color (featuring a plate with frame and a plate without frame)
• single color (featuring a plate with frame and a plate without frame)

Materials:

All these were designed and printed with PLA.

Comments on previous kitcard dice have pointed out that PETG has good results as well.

Additionally PETG doesn’t leave the fold lines you get with PLA.

This does require some further testing, so if anyone tries it with other materials, please leave a comment.