USB Cable Holder that clips in cables.
Copyright Claim
USB Cable Holder that clips in cables.
Boost
24
55
10
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
32 min
1 plate
Boost
24
55
10
0
147
115
Released
Description
This model allows fat and skinny width USB cables to clip in. Once the cable is clipped in, it won't easily come out but it can slide up and down easily.
I printed it with PETG which is a little less rigid that PLA. I think it would work with PLA though. If you try it and it works well let me know. It only take 30 minutes and not much filament.
Comment & Rating (10)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
certaines parties sont trop minces et casse pour un rien
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
ottimo perfettamente fatti un giro sul mio profilo se ti va lascia un like
0
Reply
PLA is unsatisfactory. After only a couple of times clipping cables in, several of the retainers have already snapped. Trying it again in PETG.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
(Edited)
Strength Issue
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld