Satisfying Clicking Zippo Toy
Satisfying Clicking Zippo Toy
Boost
107
136
23
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
41 min
1 plate
Boost
107
136
23
0
172
186
Released
Description
I made this satisfying Zippo replica that features the same hinge principles as the original.
The model can be printed withing an hour using 0,2 layerheights. For the hinge axles I used 0,85mm jewelery wire.
the hole in the 3D model is 1,125mm diameter.
I was quite surprised of how wel the sound compared to the original.
You can put some weight in the bottom using superglue, I used old small bolts and nuts I had laying around.
Comment & Rating (23)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
Printed well!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
very hard to assmble
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Was ok but quite fiddley.
0
Reply
great design but the rear hinge needs to be bigger it always breaks after a few flips
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
hdnwndnzmdmnd
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
the parts kept on breaking while trying to put it together. It has some potential
0
Reply
能不能模拟都彭朗声那种叮的声音
0
Reply
你好，有没有step格式，想自己修改一下进行二创
0
Reply
Nice print, but hinge is too thin. I printed it at 0.1 layer height and made it really strong, but opening and closing it a while and it broke at the hinge.
0
Reply
needs instructions on putting it together but nice print
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld