它是一个只需要依靠一个支点就可以稳定平衡的桌面摆件，你甚至可以故意去推它，它依旧平衡。

如果你是使用拓竹的切片软件，那么自动支撑可以满足打印要求，你只需要在拆除支撑时小心一点即可。

如果是使用其他切片软件，建议自己手动添加支撑不能只依据角度添加支撑（注意考虑支撑强度,以及嘴部圆锥位置的支撑），在拆除支撑时应该小心一点。

It is a desktop decoration that only needs to rely on a fulcrum to stabilize the balance, you can even deliberately push it, it is still balanced.

If you are using Takutake's slicing software, then the automatic support can meet the printing requirements, you just need to be careful when removing the support.

If you are using other slicing software, it is recommended that you manually add the support yourself, not only according to the Angle of the support (pay attention to the strength of the support, and the mouth cone position of the support), you should be careful when removing the support.