I really like the Outcome of the Print. I didnt use pillars, so the front edge of the Helmet above the eyes and nose was a bit fuzzy. One Minute of sanding and it was matching the great appearance of
the Print. :-)
Hi! Thank you for the feedback, could I perhaps find out more about what settings you used along with material? I suspect it might be humidity because my first few prints had that same issue with overhangs before I put dessicant boxes in my AMS
I see, perhaps it might be a sensor issue. Have you tried alternative sensors? Also, where were the problematic overhangs located on the object? (If you can recall)