Search models, users, collections, and posts
180° Bambu Lab X1C Door Hinge V2
Remixed by
IP Report
Print Profile(2)
0.2mm layer, 2 walls, 15% infill
Designer
1.5 h
3 plates
0.2mm layer, 2 walls, 15% infill
25 min
1 plate
Open in Bambu Studio
Boost
108
266
26
7
373
77
Released
Description
I suggest using the .3mf file provided for convenience.
The part of the hinge that attaches to the glass door, has a void in the middle. This is for the print to be paused and the female end of a 6mm binding screw to be glued in place.
(DO NOT USE THIN SUPER GLUE!! You don't want it dripping down onto the build plate. Use a gel super glue. ) I printed with a .2mm layer height and inserted a pause at the beginning of layer 47.
If you don't want to use the binding screw you can use the arms and gaskets from V1. This uses PETG (hinge body), TPU (gaskets) and PLA (supports).
The part of the bottom hinge that is mounted to the frame should be printed with 100% infill.
Guide for removing the old hinges and mounting the new ones.
Comment & Rating (26)