IMPORTANT: READ BEFORE PRINTING

There are two 3MF files. First one is for people with an AMS. Just load the filaments as below and go.

The second profile is for people with NO AMS. The pauses are set at the correct layers so all you have to do is load the black to start then at each pause unload and load the correct filaments in order as below and hit resume. Repeat until complete.

Avoid other print profiles that try to save time by using a thicker layer height. This layer height is necessary to blend the colors. I have already added a layer height modifier to the black to print 0.16 layer height for the non-blended portions to speed up the print without sacrificing quality.

This is a filament painting of your friendly neighborhood Spider-Man, as a companion piece to this VENOM. Like all of my models this is for personal use only. If you would like to hang this here is my frame which fits it perfectly. The photo attached is the printed model and frame.

Like all Hueforge prints this model produces very little waste (4 poops total).

Some of my other prints have more notes and tips for first time Hueforge printers.

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm (Layer height modifier can be added manually if you are using the STL (0.00 to 0.64mm @0.16 layer height to shave off about a half hour of print time. It is already done in the 3MF files attached)

Filaments Used:
PLA PolyLite Black Transmission Distance: 0.3
PLA BambuLab Basic Blue Gray Transmission Distance: 3.1
PLA BambuLab Basic Silver Transmission Distance: 0.5
PLA BambuLab Basic Jade White Transmission Distance: 5

Swap Instructions:
Start with Black
At layer #12 (1.04mm) swap to Blue Gray
At layer #18 (1.52mm) swap to Silver
At layer #23 (1.92mm) swap to Jade White for the rest.

If you print this model please like and post your makes with ratings. Happy Printing!