Print Profile(2)
0.28mm layer, 2 walls, 15% infill
Designer
1.7 h
2 plates
0.2mm layer, 2 walls, 15% infill
1.7 h
1 plate
Open in Bambu Studio
Boost
24
61
4
1
73
45
Released
Description
a 3D printed counter for tabletop games. counts from 0-99.
Required:
2x M3 x 12mm
1x rollerpen spring
Comment & Rating (4)
All
Print Profile
0.28mm layer, 2 walls, 15% infill
After about 100 rotations, the gear misaligned and I had to put it back together again. This issue happens frequently.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Worked well. The turning is a little stiff, but hoping it will lossen up over time.
(Edited)0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
works well, support was a little hard to remove from where the tensioner fits. also might be useful to add a little resistance to the inner ring.
(Edited)0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld