Firelamp

A fire lamp I designed; consists of three parts: top, middle, and bottom.

The middle and bottom can assembled in the slicer and printed in one piece if you have AMS, or you can print them separately and assemble them later (the middle was originally designed to be printed in resin, hence the "V" holes at the bottom that serve as vent holes, tested and working on FDM 😊).

No supports should be needed if printed separately. If printed together, some supports might be required for the opening of the cable.

The ESP must be mounted upside down to access the pins (just like the pic).

A video of my full building process can be seen here (in french).

Additionally, you will need the following:

An ESP8266 with NodeMCU-CH340 board.

-Link

Install WLED on the ESP.

-Website

-Tutorial

Four 8-10mm long M3 screws.

-Link

Two small zip-ties.

-Link

Three single dupont connectors.

-Link

A led matrix.

-Link

Any micro USB cable and charger.