Minecraft Steve Ball and Socket
Copyright Claim
Minecraft Steve Ball and Socket
Boost
58
88
22
Print Profile(2)
0.2mm layer, 3 walls, 10% infill
Designer
57 min
1 plate
0.16mm layer, 2 walls, 15% infill
1.6 h
1 plate
Open in Bambu Studio
Boost
58
88
22
4
237
285
Released
Description
Build a Minecraft Steve. No glue, parts just snap into place using a print in place ball and socket. Has decent movement without adding more joints. Recommend using a strong filament. Enjoy!
Comment & Rating (22)
All
Print Profile
0.2mm layer, 3 walls, 10% infill
Could be a I was a little tired by the time I got to him, but the ball joints were a little hard to snap on.
Great mini model regardless!
The designer has replied
0
Reply
Thanks for the make. If your filament fairly strong it might be harder to break away the built in supports. Tried a little bit larger but then joints on average were far too loose. Other possibility is a slight over extrusion as the tolerances are very tight.
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
Tisk se nepovedl napoprvé i když jsem měl dobře odmaštěnou podložku tak malé kloubové spoje se mi neudrželi na podložce až když jsem nastavil 2mm brim.
0
Reply
Print Profile
0.2mm layer, 3 walls, 10% infill
The child liked it very much )
0
Reply
Print Profile
0.2mm layer, 3 walls, 10% infill
Neffe freut sich Figur ist super geworden gedruckt mit Bambu Lab A1
1
Reply
Print Profile
0.2mm layer, 3 walls, 10% infill
Nice design, easy to print.
1
Reply
Boosted
awesome simple model easy to assemble.
0
Reply
Print Profile
0.2mm layer, 3 walls, 10% infill
really nice steve
0
Reply
Print Profile
0.2mm layer, 3 walls, 10% infill
worked very well, had to use a lot of force but thats normal for printing action figures.
0
Reply
Print Profile
0.2mm layer, 3 walls, 10% infill
1
Reply
Print Profile
0.2mm layer, 3 walls, 10% infill
1
Reply
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld