This air tag holder will work with any surface that is 2mm thick. You just need to drill a 32mm hole.
Printing instructions
- Print in TPU,
- 0.2mm layer height is fine
- A textured plate is preferred
- No need for supports
- Pro tip: dry your TPU before printing. Trust me.
- If you have troubles inserting, then don't use infill for the top part of the insert
Assembling instructions
- Drill a 32mm hole
- Push the air tag into the base of the holder, with the silver disc towards you
- Insert the insert
- Then insert the holder into the hole.
Do you like it? Like my design! Did you print it? Share your print! Thanks!