Search models, users, collections, and posts
Print Profile(1)
0.2mm layer, 2 walls, 5% infill with Tree Supports
4.7 h
1 plate
Open in Bambu Studio
Boost
49
158
3
2
79
33
Released
Description
It works really well and can be hard to screw in at first. I usually need to play with it for a little bit before it starts to screw very smoothly and nicely. Also, this will need support. I suggest using the tree supports. Other supports can mess up the quality and make it not screw in all the way and are a pain to remove. There are two types to print, and I suggest the one with the hole in the top. It makes it easy to replace the top part if it breaks.
License
This user content is licensed under a
Creative Commons Attribution-NoDerivatives
Comment & Rating (3)