AMS Lite Anti-Rubbing Spool Spacer
Print Profile(1)
Description
Membership
If I can't fight the pirates at least I can offer a proper way to sell my designs. Commercial membership is finally available!
If your spool is rubbing against the AMS or if you find it hard to remove your cardboard spool, you can try this print.
This accessory is designed for my Ultimate AMS-Lite Enclosure, but it also works to solve the same problem especially with cardboard spools even if you are not using the enclosure. When installed, this accessory pushes the spool slightly outwards (1.5mm). The benefits are as follows:
- It prevents the cardboard spool from getting a strong grip on the spool holder, allowing for easier release.
- Reduces or prevents the spool from rubbing against the enclosure.
Thanks!
Instructions
- Don't adjust the print profile as the layer height is crucial to the success of this print
- To install it, push the plate down to the base of the spool holder
- Wrangle the clips while you turn it 30degrees to lock it into place.
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (335)