If you like my work, i'm open for donations via Paypal. It is much appreciated.
https://www.paypal.com/donate/?hosted_button_id=3KZUPFUG4KLUL

4-color HueForge Pikachu, enjoy! ;-)

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

Filaments Used:
PLA Bambu PLA Black Transmission Distance: 0.3
PLA Bambu PLA Red Transmission Distance: 5
PLA Bambu PLA Yellow Transmission Distance: 5
PLA Bambu PLA White Transmission Distance: 6

Swap Instructions:
Start with Black
At layer #10 (0.88mm) swap to Red
At layer #16 (1.36mm) swap to Yellow
At layer #22 (1.84mm) swap to White for the rest.

Reminder:

My models mostly cover the entire bed,
this means the purge line is sometimes
running through the bottom of the print.
You have 3 options here:
- Leave as is, you can just cut them of afterwards.
- Remove immediately after the purge line is printed.
- Scale the model:

*** WARNING ***
WHEN SCALING THE MODEL, BE SURE TO NOT SCALE THE Z-HEIGHT!
The Z-height must always be as original, otherwise the print
is messed up.