Search models, users, collections, and posts
Apple Watch Charger
Print Profile(1)
0.2mm layer, 2 walls, 90% infill
Designer
7 h
4 plates
Open in Bambu Studio
Boost
69
185
34
25
516
326
Released
Description
Apple Watch Charger.
A simple Apple Watch Charger in four variants, although the larger one will work for all watches if you prefer it.
- Apple Watch Charger v4 - S 40-42mm : for standard 40 to 42mm iWatch no strap holder.
- Apple Watch Charger v4 - S 40-42mm - Strap : as above with strap holder.
- Apple Watch Charger v4 - L 44-49mm : for larger iWatch including Ultra, no strap holder.
- Apple Watch Charger v4 - L 44-49mm - Strap : as above with strap holder
Recommend printing with 90% infill for extra weight, uses around 40g of filament and takes approximately 2 hours to print. It does print without supports, but if you want to, use organic supports on the build plate only.
I've added the strap retainers at the rear just because I think I may have a slight case of OCD :)
Watch Strap Retainers
Cable Routing.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (34)