Pliers holder for Ikea SKÅDIS
Copyright Claim
Pliers holder for Ikea SKÅDIS
Boost
75
226
22
Print Profile(2)
0.2mm layer, 3 walls, 15% infill
53 min
1 plate
PET-G, 0.2mm layer, 3 walls, 15% infill
54 min
1 plate
Boost
75
226
22
1
395
187
Released
Description
This is a simple holder to hold a pair of pliers on an Ikea SKÅDIS peg board.
There are two designs where the big one has a width gap at the smallest point of the holder prongs of 41.7mm, whilst the smaller one has a width gap of 34.7
These are designed specifically for the Draper Redline range, but should work with anything of a similar size and shape.
I hope you enjoy printing and using my design. To help me keep designing and uploading more things, you can tip me via 'Buy Me a Coffee' here: https://www.buymeacoffee.com/JoshForwood
If you're after other Skadis mounts, I've made a collection of my Ikea SKÅDIS designs here.
Comment & Rating (22)
All
Print Profile
0.2mm layer, 3 walls, 15% infill
Thank you very much for this design 👍
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
perfectly printed.
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
nice thanks!
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
Qualität ist super,
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
passt wunderbar
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
Good stuff
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
Passt leider nicht in die Löcher. Musste extrem viel nacharbeiten.
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
passt perfekt
0
Reply
License
This work is licensed under a
Creative Commons Attribution-NoncommercialRemixes (1)
© 2024 MakerWorld