IKEA Skadis/ Skådis Brush Holder - T Clip
Copyright Claim
IKEA Skadis/ Skådis Brush Holder - T Clip
Boost
42
104
20
Print Profile(1)
0.18mm layer, 3 walls, 15% infill
Designer
1.1 h
1 plate
Open in Bambu Studio
Boost
42
104
20
0
131
54
Released
Description
A brushes holder for IKEA Skadis boards.
Mounted using the T-Clip System by Line Arc Line. You can also use T-Clips mini by capze or Low Profile T-Clips by tchoupshop to fit flush. The clips come in two versions - one for black/white Skadis boards, and one for unpainted ones (not included here; please download from the creator).
I made a T Clip tool to make turning the clips easier, especially the flushed version.
Comment & Rating (20)
All
Print Profile
0.18mm layer, 3 walls, 15% infill
Good!!
The designer has replied
1
Reply
Thank you for the picture and feedback! 🤩
0
Reply
Print Profile
0.18mm layer, 3 walls, 15% infill
The designer has replied
0
Reply
Hi! Thank you for the rating. Were there any issues with the print?
0
Reply
Hi, not a big issue. I had a problem during first printing because it detached from plate.
I added brims to solve.
it is also possible the problem was relatd to the plate not well cleaned.
I found also some difficult to insert my little brushes because the handle has different bending.
0
Reply
Print Profile
0.18mm layer, 3 walls, 15% infill
0
Reply
Print Profile
0.18mm layer, 3 walls, 15% infill
Lässt sich trotz des T Clips an der Wand bewegen. Sonst ok.
The designer has replied
0
Reply
Did you make sure you printed the right T-Clips? You have to choose based on the type of board you have, if it is a painted one or a bare wood one.
0
Reply
Replying to @ZEESOLO
Yes i think so, T-Clip for painted skadis.
0
Reply
Print Profile
0.18mm layer, 3 walls, 15% infill
works good
1
Reply
Print Profile
0.18mm layer, 3 walls, 15% infill
1
Reply
Print Profile
0.18mm layer, 3 walls, 15% infill
1
Reply
Print Profile
0.18mm layer, 3 walls, 15% infill
1
Reply
Print Profile
0.18mm layer, 3 walls, 15% infill
1
Reply
Print Profile
0.18mm layer, 3 walls, 15% infill
1
Reply
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld