shark snodato
Copyright Claim
shark snodato
Boost
19
36
13
Print Profile(1)
0.16mm layer, 2 walls, 25% infill
Designer
45 min
1 plate
Open in Bambu Studio
Boost
19
36
13
0
102
120
Released
Description
Jointed shark
Comment & Rating (13)
All
came out great on A1 mini though mouth wont open
(Edited)
1
Reply
Print Profile
0.16mm layer, 2 walls, 25% infill
really cool design, however 2 out of 4 had a fin needing glued in place as breaking it loose broke it off and one of the jaws had a socket break and half the teeth tips came off when I broke it loose also, if it was scaled up a bit more and if the fin wasn't sideways it would be perfect, would rate 5 stars but with 50% success I gotta say it's not perfect, but it may come out better to someone else with different filament or something
0
Reply
Print Profile
0.16mm layer, 2 walls, 25% infill
Printed perfectly, jaw joint is slightly fragile.
0
Reply
Print Profile
0.16mm layer, 2 walls, 25% infill
very nice
0
Reply
Print Profile
0.16mm layer, 2 walls, 25% infill
quite small
0
Reply
Print Profile
0.16mm layer, 2 walls, 25% infill
Turned out great!
0
Reply
Print Profile
0.16mm layer, 2 walls, 25% infill
turned out great! small enough you can fill the print bed with them if you would like a large batch
0
Reply
Print Profile
0.16mm layer, 2 walls, 25% infill
Good print. Mouth opens, but had to initially use tweezers to pry open!
0
Reply
Print Profile
0.16mm layer, 2 walls, 25% infill
0
Reply
Print Profile
0.16mm layer, 2 walls, 25% infill
0
Reply
© 2024 MakerWorld