Pass-n-Thru Flower Pot

Here's my take on a fidget/desk decoration. This uses passthrough/vortex parts to create a Flower Pot that can "grow" a flower.

I printed this with various PLA at .2 layer height, no supports or extra parts needed.

Here are what's included on the provided profile:

Pot and Base = The flower pot comes in two parts. The main pot is where the flower is "planted" and then the base will twirl into the main pot causing the flower to "grow". For me, initially the pot does not fall on own, like shown in gif, but over time it smoothens out for me.

Plants:

I include a few different "style" of plants, just pick the one that you like best and choose your colors.

Multi-color is achieved by layer height changes, so if no AMS, can still get the effect by putting a pause and manual change. All Layer heights referenced below are assuming a .2 layer height. Of course, can experiment in Slicer with different color changes.

• Flower 1 = Color Change at Layer 182
• Flower Short = Color change at Layer 162
• Piranha Plant = Color Change at Layer 222 and at 278
• Tree = Color Change at Layer 244

Flower Shell = This is a shell that snaps into the top of the Flower Pot to offer additional effects if desired. Printing this is optional. I did color change at Layer 166.

I include the shell to highlight that the Pass-n-Thru flower pot is fully compatible with my Pass-n-Thru - Passthrough Fidget System (Magnets) by evets17 - MakerWorld.

The twirlies and shells in my other Pass-n-Thru listing will work with the flower pot and vice versa.

NOTE: the flowers here can take 3x6 magnets in line with my design language for Pass-n-Thru, but are not needed or necessary for just the flower pot. But can make some other effects:

As always, if anyone does take time to print this, I would love to see pictures and hear how things went.

Thanks for reading.