Apple Watch Band Box with Logo and 20mm Latch

Over the years I collected quite a few Apple Watch Bands but I couldn't find a good solution to store my Bands in a good way. So I came up with my own design wich is based on the Rugged Box

Printing & Assembling

I would recommend printing at a 0.2mm layer height. 2 latches are needed. Printing the TPU seal isn't needed unless you want to water tighten the case. The latches and hinges are made to fit M3x20.

The Insert sits very tight in the bottom part of the box, no glue is needed.

The Slots

There are 3 different sizes of Slots

S fits the Solo Loop and Silicon Solo Loop

M fits the Sport Loop, Trail Loop, Alpine Loop, Milanese Loop and thin Leather Bands

L fits the Ocean Band and thinker leather bands

Inserts

There are different inserts with different slot sizes. Pick the one you need. More variations will come in the future.