Print Profile(2)
0.2mm layer, 1 walls, 0% infill
Designer
2.3 h
1 plate
0.2mm layer, 2 walls, 15% infill
Designer
3.5 h
1 plate
Open in Bambu Studio
Boost
17
29
2
0
36
10
Released
Description
supports.
The upper part can be made in vase mode or with two walls if you prefer a greater resistance. the bottom will then be drilled with a cup cutter or a cutter.
The hole in the base has been shaped to accommodate an E27 socket.
The lamp is more pleasant when accompanied by a warm light.
Good printing!
Comment & Rating (2)
All
Print Profile
0.2mm layer, 1 walls, 0% infill
After a few rounds of optimizing the material and slicer settings, it turned out to be a very nice lamp. I cut out the hole in the base in the slicer and printed the base a little thicker. Super design.
1
Reply
Print Profile
0.2mm layer, 1 walls, 0% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld