Christmas lantern prepared to put four different designs.
Prepared to place an LED candle up to 38mm inside.
Access to the LED candle is made from below with a threaded lid to make it easier to turn it off and on.
To place the different designs you only have to remove the four nuts that hold the top cover and fit them through the rails.
Use two walls and 15% infill for all the pieces of the lantern, that is enough since it is not a design that requires too much strength, and thus you will save material and printing time.
The fronts are best printed with 100% infill.
It has been designed leaving a certain tolerance so that the pieces fit in fairly but without problems, but it is also recommended that you take into account the tolerances of your printer.
There are thirteen different designs so you can put the ones you like the most.
Hope you enjoy.
2023-11-16
Corrected:
Small tolerance adjustments to make it easier for everything to fit
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.