This Lid Extension addresses a few issues; the PTFE tube rubbing on the underside of the lid, the need for a little more light, need to vent heat out of the enclosure when printing with PLA.
The assembly is simple, just four parts for the frame, a bracket for the LED controller, and two slides.
All of the parts are listed in the BOM (included) and sources for the LED and weather stripping.
FYI: The LED strip might pull too much power, causing the LED lights to flash on and off. I was able to cut the LED strip down to cover 3 sides of the Lid Extension and have no power problems. I applied the LED lights to the Front, Right, and Rear of the enclosure to reduce any shadows.
Print Profile for the entire project on one plate and Profiles for the individual parts are provided.
COMING SOON
*Watch for another version of the Lid Extension designed more for the X1 series with power cable egress.
For more information, be sure to watch the Youtube video: