Search models, users, collections, and posts
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
9.8 h
5 plates
Open in Bambu Studio
Boost
425
898
47
37
833
411
Released
Description
Boost Me (for free)
If you appreciate the work i do, consider leaving me some boost.
Thank you!
Flower pot in the second picture.
The pot can be inserted into any flower pot you would like, that's why there is only a basic one.
The diameter of the pot at 100% is 6cm and the tolerance on the pin is 0.2mm.
To make it fit into the flower pot in the second picture I scaled it down to 58%. The fit was quite tight.
Printing
Only cactus_3 needs supports. I used tree supports.
Filaments used: Prusament Army green PLA for the cactuses, Wood PLA for the pot.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (47)