Search models, users, collections, and posts
Perfect Wall Hook
IP Report
Print Profile(2)
0.2mm layer, 6 walls, 25% infill
Designer
28 min
1 plate
vertical & horizontal orientation, 25% gyroid, extend length
1.8 h
1 plate
Open in Bambu Studio
Boost
476
1190
303
95
3.9 k
3 k
Released
Description
Perfect wall hook/hanger designed to be used with 2 strips of 3/4" (19mm) wide double-side glue tape.
Provides maximum contact area for strongest adhesion.
Hook is designed to be used with anything: towels, shoes, jackets, keys (both big and small keyrings), tools, etc.
It is small enough for tidy loops, yet deep enough to hold towels securely. Sharp internal edges give better grip, while smooth front finish - ease of use.
It has enough flat area for markings.
Ultimately simple no-compromise design.
Should be printed with “wall” side facing buildplate (plus support under the hook end).
Can be printed in alternated angle for better strength, but post-processing of “wall” side is required to provide best glue adhesion.
- Hilbert Curve top surface pattern is advised for better finish (result on the photos)
License
This user content is licensed under a
Creative Commons Attribution
Comment & Rating (303)