P1P+P1S Latching Top Cover Plug
Copyright Claim
P1P+P1S Latching Top Cover Plug
Boost
110
230
155
Print Profile(2)
0.12mm layer, 3 walls
11 min
1 plate
0.16mm layer, 3 walls, 10% infill
9 min
1 plate
Boost
110
230
155
1
722
567
Released
Description
A plug for the P1S / P1P hole with latches do keep it in place. It snaps in place and stays there. I printed it in Bambulab Basic PLA and it works.
Comment & Rating (155)
All
Print Profile
0.16mm layer, 3 walls, 10% infill
Works great! Perfect fit! Thank you!
1
Reply
Thanks for sharing the picture of your print!
0
Reply
Print Profile
0.12mm layer, 3 walls
Fit great!
1
Reply
Thanks for your comment and for sharing your photo!
0
Reply
Print Profile
0.16mm layer, 3 walls, 10% infill
Printed great. Snaps into place as described, but is also pretty easy to remove if needed for some reason.
1
Reply
nice model 😀
The designer has replied
0
Reply
Thanks!
0
Reply
Print Profile
0.12mm layer, 3 walls
Ottimo entra perfettamente
0
Reply
Thanks for sharing the picture!
0
Reply
Print Profile
0.12mm layer, 3 walls
good print
0
Reply
Thanks, glad you like it! Thanks for sharing the picture of your print.
0
Reply
Print Profile
0.12mm layer, 3 walls
fits perfectly
0
Reply
Great, and thanks for sharing your picture.
0
Reply
Print Profile
0.12mm layer, 3 walls
thanks for the model, fits well with the latches
0
Reply
Glad it works! :-) Thanks for sharing your picture.
0
Reply
Print Profile
0.16mm layer, 3 walls, 10% infill
great
0
Reply
Print Profile
0.12mm layer, 3 walls
printed fine and a good fit
0
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld