A-Maze-Ing Cube
Copyright Claim
A-Maze-Ing Cube
Boost
62
149
6
Print Profile(2)
Brims | Original-Colors | 0.2mm layer, 2 walls, 15% infill
9.7 h
3 plates
for A1 Mini | Brims | Original-Colors | 0.2mm layer, 2 walls, 15% infill
11.7 h
6 plates
Open in Bambu Studio
Boost
62
149
6
1
156
101
Released
Description
It's a maze! It's a cube! It's surprisingly addictive.
Fits 3/8" ball bearing (anything smaller than 10mm). Print one of each corner and 6 brackets. Corners are labeled, just match up the letters to the corresponding corners.
I also made a set that is pre-supported to help make sure they don't fall over while printing.
Comment & Rating (6)
All
Print Profile
Brims | Original-Colors | 0.2mm layer, 2 walls, 15% infill
Fun build. My kids definitely thought it was a neat finished build.
0
Reply
Print Profile
Brims | Original-Colors | 0.2mm layer, 2 walls, 15% infill
One of my favorite models! Printed flawlessly and was super easy to assemble. Very fun to play with!
1
Reply
Is there a start and end?
0
Reply
fyi: 3/8" is ~10mm not cm
0
Reply
Print Profile
Brims | Original-Colors | 0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
Brims | Original-Colors | 0.2mm layer, 2 walls, 15% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld