9V Battery Latch for Traeger Flatrock
9V Battery Latch for Traeger Flatrock
Boost
1
2
4
Print Profile(0)
Add the first print profile to earn points
Boost
1
2
4
0
2
0
Released
Description
Simple clip to slide over the Traeger Flatrock 9 volt battery box to prevent it from falling out. Used the opportunity to practice in OnShape and draw something up. Feel free to improve upon it!
I used ASA since it will be outdoors, print setting should not be critical I used .2 layer height, 4 walls, 4top/bottom and 15% gyroid, took about a half hour on my V0.2
Comment & Rating (4)
All
I printed this and tested it out. Worked perfect, it was the perfect size too but while i was out there I called Traeger and complained and they told me they are sending a new part that has been redesigned. Hopefully I wont need this.
(Edited)The designer has replied
0
Reply
let me know when you get the replacement if it is different and it works! I got a replacement but it is same design and same issue but that was just a couple months after it released so maybe they finally updated design!
0
Reply
Replying to @Flyrockets
Turns out they lied to me, it's the same design. Probably wont even change it out, I'll just use your fix, Thanks for sharing!
0
Reply
same thing I did put it in the shelf in basement in case something ver breaks but didn’t bother swapping!
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution
© 2024 MakerWorld