Print Profile(2)
0.24mm layer, 2 walls, 15% infill
Designer
2.2 h
1 plate
Arachne, gyroid, skirt, 2 plates, 0.24mm layer, 2 walls, 15% infill
2.4 h
2 plates
Open in Bambu Studio
Boost
35
64
27
0
120
136
Released
Description
A simple lid box with a Celtic Knot decoration (10x10x4.5 cm)
Comment & Rating (27)
All
Print Profile
0.24mm layer, 2 walls, 15% infill
Nice fitting and good looking. Thank you very much!
1
Reply
Print Profile
0.24mm layer, 2 walls, 15% infill
very neat box, I love the result. thank you so much ❤️
1
Reply
Print Profile
0.24mm layer, 2 walls, 15% infill
1
Reply
Print Profile
0.24mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.24mm layer, 2 walls, 15% infill
little warping on bottom of the box but works great and looks amazing
The designer has replied
1
Reply
On my x1c sometimes the warping 8s caused by the side auxiliary fan. usually It spims at 70% but It Is too much during the iniziale layers. try to print It with a reduced auxiliary fan.
or try to move the print on the right side of the plate and out the prime tower directory in front of the side fan.
0
Reply
Print Profile
0.24mm layer, 2 walls, 15% infill
nice box
0
Reply
Print Profile
0.24mm layer, 2 walls, 15% infill
Support Issue:df
The designer has replied
0
Reply
very strange. there Is no Need for support and It prints flawless without with the top and bottom faces down the plate
0
Reply
Print Profile
0.24mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.24mm layer, 2 walls, 15% infill
Other Issues:First layer causing not so perfect look at the top
0
Reply
Print Profile
0.24mm layer, 2 walls, 15% infill
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld